Download installazione
Transcript
Manuale tecnicoDT0342 ediz. 03 - Technical handbook DT0342 Issue 03 ATLAS 60 -120 kVA 2.2.3. Allacciamento delle utenze 2.2.3. User connection E' consigliato collegare a valle dell'UPS un apposito interruttore magnetotermico quadripolare “Curva C” (vedere fig. 2.2 e fig. 2.4). Its suggested to connect a four-pole “Curve C” magnetothermic switch at the output of the UPS (see Fig. 2.2 and Fig. 2.4). LE OPERAZIONI DESCRITTE IN QUESTO PARAGRAFO DEVONO ESSERE ESEGUITE DA ELETTRICISTI AUTORIZZATI O DA PERSONALE TECNICO QUALIFICATO. THE OPERATIONS DESCRIBED IN THE PARAGRAPHS THAT FOLLOW MUST BE CARRIED OUT BY AUTHORIZED ELECTRICIANS OR BY TECHNICAL PERSONNEL. I collegamenti devono essere effettuati nelle seguenti condizioni: - assenza della tensione primaria di rete; - assenza della tensione di betteria - utenze disattivate; - UPS totalmente disattivato. The wiring operations must be carried out under the following conditions: - primary mains voltage cut off; - battery voltage cut off;.- users cut-off; - UPS fully de-activated. interruttore magnetotermico quadripolare “Curva C” four-pole “Curve C” magnetothermic switch QUADRO DI DISTRIBUZIONE ALLE UTENZE LOAD DISTRIBUTION PANEL magnetotermico differenziale 1 safety magnetothermic 1 presa utenza 1 User socket 1 La barra presente sotto gli interruttori consente l'ancoraggio del cavo all'UPS stesso mediante l'impiego di fascette fermacavi. magnetotermico differenziale 2 safety magnetothermic 2 presa utenza 2 User socket 2 magnetotermico differenziale ...n safety magnetothermic ..n presa utenza n User socket n The bar near the switch blocks can be used to fasten the cable to the UPS through cable clamps. UTENZA 1 - USER 1 UTENZA 2 - USER 2 UTENZA-n / USER-n Fig. 2.4 - Quadro di distribuzione alle utenze Load distribution Panel Installazione Installation 2 - 13 INSTALLAZIONE - INSTALLATION 2