Download EPD Series

ircuit is required. The dehumidifier draws approx. 8 amps at
0°F, 60% RH. If used in a wet area, a ground fault interupter (GFI) is required.
Hour
Button
(Fig.
4)
For your
safety and
protection
this appliance is manufactured
Press
HOURS
button
when
thecord.
dehuwith a the
grounded
plug
on its
power
The power cord must
3
midifier
cannot
be
plugged
in
and
the
be plugged into a properly groundedhour
receptacle. If a groundmeter
needs todoes
be read.
Thehave
digitalone
hour
ed receptacle
not exist,
installed by a certified
meter
will
display
the
last
saved
cumulative
electrician. Do not cut or remove the grounding prong on the
Built in Electrical Safety
time
forcord
ten seconds.
power
plug if equipped. We recommend thatFig.
this 4electriFor your safety and protection this appliance is manufactured
cal
circuit/receptacle
operate
under
a
separate
breaker or
Electrical
with a grounded
plugRequirements
on its power cord. The power cord must
fuse.
Forinto
115V
common grounded
outlet Ifonaa ground15 amp circuit is required.
If used
in a wet area, a ground fault interrupter (GFI) is required.
Battery
Replacement
e plugged
a operation,
properly agrounded
receptacle.
If
an
extension
cord is required, it must have a minimum of
d receptacle does not exist, have one installed by a certified
Built
in
Electrical
Safety
14
gauge
conductors
if 25 feet long or less and 12 gauge
lectrician. Do not cut or remove the grounding prong on the
For your safety and protection this appliance is manufactured with a grounded
plug on itsifpower
cord.than
The power
cordlong.
must be plugged into a properly
conductors
greater
25 feet
ower cord plug if equipped. We recommend that this electrigrounded receptacle. If a grounded receptacle does not exist, have one installed by a certified electrician. Do not cut or remove the grounding prong
al circuit/receptacle operate under a separate breaker or
on the power cord plug if equipped. We recommend that this electrical circuit/receptacle operate under a separate breaker or fuse.
use.
Water Removal
B
Industrial Dehumidifier
WARNING
The dehumidifier
is equipped
an internal
condensate
If an extension
is required,
it must
have aa minimum
of of
14 gauge conductors
if 25 feet long
or less andwith
12 gauge
conductors
if greater pump
than 25
an extension
cord iscord
required,
it must
have
minimum
to
remove
the
water
that
is
collected
from
the
air.
This
allows the
long.
4 gaugefeet
conductors
if 25 feet long or less and 12 gauge
water to be pumped 20 feet with the attached hose. If the water
onductors if greater than 25 feet long.
Electrical Shock Hazard
Limitations of Use
needs to be pumped more than 20 feet above the unit, a second
Plugmust
into abe
grounded
prong
outlet.
Disconnect
power
before
replacing
battery.
Temperature: 4°C to 35°C (40°F to 95°F)
pump
addedsupply
to3relay
the
water.
The condensate
pump
Water Removal
Relative Humidity: 20 to 80%
automatically
purges
for
20
seconds
every
four
minutes.
Do not remove
prong.
Failure
to followground
these instructions
can result in death,
The dehumidifier is equipped with an internal condensate pump
fire, or electrical shock.
Do not use an adapter.
o remove Water
the water
that is collected from the air. This allows the
Removal
water to beThe
pumped
20
feet
with
the
attached
hose.
If
the
water
dehumidifier is equipped with an internal condensate pump to remove the water that is collected from the air. This allows the water to be pumped
Disconnect dehumidifier from power supply. The hour meter uses
eeds to be
than 20
feetIf above
theneeds
unit,toa be
second
20pumped
feet with more
the attached
hose.
the water
pumped more than 20 feet above the unit, a second pump must be added to relay the water.
a battery backup for display when the dehumidifier is unplugged
ump mustThe
becondensate
added topump
relayautomatically
the water. The
condensate
pump
Place dehumidifier inside area to be dried. Make sure all winpurges
for 20 seconds
every four minutes.
and the hour button is depressed. To change the battery, it is necutomatically purges for 20 seconds every four minutes.
dows and doors are closed to the outside and seal off the wet
essary to remove the four (4) screws from the control panel.
area from any unaffected areas. Route condensate hose into
Disconnect the old battery and replace with new battery. Replace
a drain, or a very large container. Press the On/Off button
control panel and screws. Do not overtighten screws.
(Fig. 1) to activate the dehumidifier.
D
a
a
e
D
co
OPERATION
D
W
tr
th
u
th
cy
OPERATION
Operation
lace dehumidifier inside area to be dried. Make sure all winCycle
Place dehumidifier inside area to be dried. Make sure all windows and Defrost
doors are closed
to the
Power
Button
(Fig.
1)
ows and doors are closed to the outside and seal off the wet
When
iceinto
builds
up or
on the coils, a thermistor activates the elecoutside and seal off the wet area from any unaffected areas. Route condensate
hose
a drain,
The
dehumidifier
is
turned
on or off by
rea from any unaffected areas. Route condensate hose into
tronic control and defrost light. The compressor is turned off by
a very large container. Press the On/Off button (figure 1) to activate the dehumidifier.
pressing
the
power
button.
When the
drain, or a very large container. Press the On/Off button
the thermistor temperature measurement. The blower will contindehumidifier
is
started,
the
hour
meter will
Fig. 1) toStart-up
activate the
dehumidifier.
ue to run, causing air to flow through the evaporator coil and melt
Mode
display the cumulative hours.
theWhen
ice. When
the ice is melted, the thermistor will end the defrost
The dehumidifier is turned on or off by pressing the power button (figure 1).
the dehumidifier
Figure 1
Fig. 1
cycle and
thecumulative
compressor will be started.
is started, (Fig.
the hour1)meter will briefly display the software version #, followed
by the
Power Button
hours.
The dehumidifier
is turned on or off by
ressing the power button. When the
Defrost Indicator (Fig. 5)
Pressing the power button during the first minute, the unit will go into OFF Mode immediately.
ehumidifier
is started, the hour meter will
The defrost indicator will light to indicate the
isplay the cumulative hours.
dehumidifier is in defrost cycle. During this
Run Mode
Figure 2
the compressor
Fig.
1
During Run Mode the compressor is running causing the evaporator period,
to get cold
resulting in is not running.
Fig. 5
(1)
condensate forming on the coil.
The unit will stay in run mode for variable length of time depending on the ambient conditions.
Pressing the power button (figure 1) will send the unit in shut down mode (see below)
Defrost Mode
During the defrost mode, the indicator light will turn on (figure 2), the compressor will be off and the fan
will continue to run. The pump purge will be activated automatically.
The defrost cycle runs every 45 minutes in cool ambient temperature, less often in warm ambient
temperature and the length of time in defrost will vary appropriately.
Heavy frosting on the coil can be expected during low ambient conditions and will not affect the
operation of the unit.
fantech
D
(1)
T
d
p