Download SIMNRA User's Guide

Transcript
4.3
4.3.1
Scattering kinematics
Elastic scattering
Energy of backscattered projectiles
The energy E1 of a backscattered projectile with incident energy E0 and mass M1 after
scattering is given in the laboratory system by
"
#1/2 2


M12
M2 2
2
E1 = E0
cos
θ
±
−
sin
θ

(M1 + M2 )2 
M1


(4.5)
θ is the scattering angle and M2 the mass of the target nucleus initially at rest. For
M1 < M2 only the plus sign in eq. 4.5 applies. If M1 > M2 then eq. 4.5 has two solutions,
and the maximum possible scattering angle θmax is given by
θmax = arcsin
M2
.
M1
(4.6)
The second solution for M1 > M2 is obtained because different impact parameters d result
in the same scattering angle θ. Consider for example the scattering angle θ = 0: This angle
is obtained for a head-on collision with d = 0, but also for very large impact parameters
d ≈ ∞.
SIMNRA version 3.50 and higher uses both solutions of eq. 4.5, if kinematically possible. Earlier versions of SIMNRA used eq. 4.5 only with the plus sign, the solution with
the minus sign was neglected.
Energy of recoils
The energy E2 of a recoil is given in the laboratory system by
E2 = E0
4M1 M2
cos2 θ.
(M1 + M2 )2
(4.7)
E0 is the energy of the incident projectile, M1 the mass of the projectile, M2 the mass of
the target nucleus initially at rest and θ the recoil angle, with 0◦ ≤ θ ≤ 90◦ .
4.3.2
Nuclear reactions
For the calculation of nuclear reactions kinematics we use the quantities listed in table 4.1.
We define the following quantities:
A13 =
A14 =
A23 =
E1
M1 M3
(M1 + M2 )(M3 + M4 ) ET
E1
M1 M4
(M1 + M2 )(M3 + M4 ) ET
M1 Q
M2 M3
1+
(M1 + M2 )(M3 + M4 )
M2 ET
55