Download IceWarp Server Outlook Sync User Guide

IceWarp Server
Outlook Sync User Guide
In case of outgoing server, everything as from the incoming server applies too; including the line security. It is
recommended to “Use same as incoming”, in which case all previous configuration is used and line security and port is
configured as default.
You may also test if your values are correct by clicking on “Test connection” button.
STEP 10 – INCOMING POP3 SERVER CONFIGURATION FOR GROUPWARE ONLY PROFILE
If you selected a “Groupware only” profile, you will be asked for POP3 server details.
Figure 13 – Incoming POP3 server properties (Installer page)




Username is your login; usually it is the “part” before @, e.g. [email protected] ‘s username could be
“francis”. But if your server is configured to login with email address then use [email protected] as
your username. If in doubt consult this situation with your administrator.
Hostname is the address of your server; it can be a hostname or IP address.
Port is the IMAP TCP port configured on your server. Default value is 110 for plain, or 995 for secured line.
Line security defines whether all communication between Outlook Sync and IceWarp server will be encrypted
or unencrypted (plain). Unsecured line does not encrypt any data, generally this option is not recommended.
POP3 account on Outlook does not allow you to select STARTTLS, there are only two options available for line security;
SSL (Secure Socket Layer) or Plain.
STEP 11 – FINISHING THE INSTALLATION PROCESS
After you pass through all previous pages, all what is left is a progress window after which the last page with the
summary appears. If you selected “Create profile”, no matter what type, Outlook Sync installer attempts to start
Outlook with the configuration file.
Page 19