Download Dterm PSIII User Guide

Using the PSIII
3-7
To Receive a Call
When you receive a call on your Dterm PSIII, the LED Ring Indicator will
flash (Figure 3-1).
NOTE
If the Calling Party Number is not available, “CALL” is displayed. If Calling Party
Name is not available then the calling party number will appear in the display (only
for Mode 2* systems).
Step 1
Press the L1 or L2* key (the line receiving the call).
Step 2
Begin speaking into the microphone.
If you cannot answer a call, Missed Call is displayed.
NOTE
To Use Directory Dialing
You can use Directory Dialing by searching for directory entries
manually or by name.
To Search for Directory Entries Manually
Step 1
While in a standby state, press the Scroll S key. A Directory dialog box
displays (Figure 3-8).
Figure 3-8 Directory dialog box
Directory
NOTE
Step 2
Press the Scroll T key to search the Directory in alphabetical order or
press the Scroll S key to search in reverse order.
Step 3
When you locate the desired name, press L1 or L2* to dial the number.
*Mode 2 features are only available with NEAX 2000 (Series 1900 software or later)
and NEAX 2400 (Series 7300 software or later). Zone Transceiver 5.00 software (or
later) must be used.
To Search the Directory by Name
Step 1
Dterm PSIII User Guide - Revision 1
While in a standby state, press the Scroll S key. A Directory dialog box
displays (Figure 3-8).