Download Revised Troubleshooting Handbook

Transcript
4 Blinks Error Code
If the power LED continues to blink even after the TV is unplugged, press and hold the power
switch on the TV for a few seconds until the LED turns off.
Trouble Mode
Defective Board
Power Supply SOS
Primarily P board or possible A board
TC-P42G10
TC-P46G10
TC-50G10
Warning: Disconnect AC Power prior to
making any disconnection or connection.
TC-P54G10
All other 2009 Models
Start Here
Disconnect the TV. Disconnect
P2 and P11 on the P board
Measure the resistance between
pin 1 of connector SS11 on the
SS board and ground (Chassis).
Yes
Is there a
short to
ground?
No
Yes
Start Here
Does the power
supply
makes a “chirp”
noise at plug in?
No
Measure the resistance between
pin 1 of connector SC2 on the SC
board and ground (Chassis).
Replace
the SS board
Turn the TV on
Yes
Yes
Replace
the SC board
Is there a
short to
ground?
No
P Board
Is pin
12 of CN P25 on
the P board high
before the TV
shuts down?
No
A Board
Replace
the P board
Slide #36