Download Simultaneous User Manual

32 Setting up parameters via the keypad
How particulate factors are adjusted and calculated
5. Press the Edit softkey and the Edit Profile screen will open.
Profile name
Optional: customize the
profile name
Factor
Figure 3-11: Entering a profile for particulate calibration
6. (Optional, see step seven if not changing profile name.) To change
the name of the profile, ensure the profile field is selected and
press the Enter
. Press
Arrows to change the
characters. To move to the next position, press
Arrows then
press Enter
.
7. Press
Arrow to select the Factor and press Enter
to
move to the 2nd column. Press
Arrows to change the
numeric value. Press the left/right arrow key to move to the next
position. Continue this process until the appropriate number is
selected and press Enter
to confirm or Esc key to cancel
changes.
8. Press the On/Off/Esc
to return to the particulate screen.
9. To apply a new profile, select the profile field and move to the
second column (by pressing Enter
.) Then continuously press
Arrows until the appropriate profile/correction factor is selected.
Press Enter
to return to the first column.
10. Press On/Off/Esc
twice to return to the start screen.