Download NMS Management User Guide

Contents
1.0 OVERVIEW
1.1 System Requirements
1.1.1
1.1.2
1.1.3
1.1.4
Straight-through RJ45 to RJ45 Ethernet Cable
Web Browser
MIB Browser
Screen Resolution
1.2 Multi-User Support
1.3 Default Settings
1.3.1
1.3.2
1.3.3
1.3.4
1.3.5
User Access Defaults
System Defaults
Uplink Interface Defaults
Circuit Defaults
SNMP Trap Defaults
1.4 Data Storage
1.4.1 Random Access Memory (RAM) and Non-Volatile Random Access Memory (NVRAM)
1.4.2 Local Files
1.5 Data Management
1.5.1 IP DSLAM Data Management
1.5.1.1 Replacing an Interface Module
1.5.1.2 Replacing a Multiplexer Uplink Module (MUM)
1.5.2 Clearing NVRAM
1.5.2.1 IP DSLAM
1.5.2.2 Mini DSLAM
1.5.2.3 Micro DSLAM
2.0 NMS SETUP
2.1 Establish a Connection With the Micro DSLAM, Mini DSLAM or MUM
2.1.1 Configure Your PC to Enable Communication with NMS
2.1.2 Connect your PC to the MGMT Port (Port 1)
2.1.3 Launch a Web Browser and Log In
2.2 System Configuration
2.2.1
2.2.2
2.2.3
2.2.4
2.2.5
2.2.6
Set IP Address, Subnet Mask and Gateway
Set Inband Management
Set a Management IP Address Range (Micro DSLAMs ONLY)
Set TFTP Enable
Set Inband MGMT VLAN ID (if applicable)
Submit Changes
2.3 Reconnect with NMS
2.3.1
2.3.2
2.3.3
2.3.4
2.3.5
Reconfigure IP Address and Subnet Mask on Your PC With The Original Values
Relaunch Your Web Browser and Enter the New IP Address
Make Additional Configuration Changes as Desired
Save Port Configurations to a Local File
Log Out of NMS
3.0 NMS NAVIGATION
3.1 NMS Main Window
3.1.1 Micro DSLAM Chassis Front View
3.1.1.1
3.1.1.2
3.1.1.3
3.1.1.4
3.1.1.5
210-0000048 rev 06
Power LED
Management Port and Corresponding LED
Uplink Ports and Corresponding LEDs
System Reset Button
Communication Port