1
Download Web Browser Interface User's Guide
Transcript
AT-S63 Management Software Web Browser Interface User’s Guide Configuring the SNMPv3 Notify Table You can create, delete, and modify an SNMPv3 Notify Table entry. See the following procedures: “Creating a Notify Table Entry” on page 263 “Deleting a Notify Table Entry” on page 265 “Modifying a Notify Table Entry” on page 266 For reference information about the SNMPv3 Notify Table, see Chapter 22, “SNMPv3” in the AT-S63 Management Software Menus Interface User’s Guide. Creating a Notify Table Entry To create an entry in the SNMPv3 Notify Table, perform the following procedure: 1. From the home page, select Configuration. The Configuration System page is displayed with the General tab selected by default, as shown in Figure 5 on page 38. 2. Select the SNMP tab. The SNMP tab is shown in Figure 89 on page 234. 3. In the SNMPv3 section, click the button next to Configure Notify Table, and then click Configure at the bottom of the tab. Section III: SNMPv3 263
