Download DP User Manual
Transcript
Once the settings for the step fitting are reasonable, the table of values can be saved from the software using the Save Step Table button in the operation panel. The save dialog shown here prompts for the location and name of the file. The data is always saved as a plain text (ASCII) file. The final data column, p-Value, is a measure of the significance of the step. A smaller value gives a larger statistical weight to the step. 6.4.10 Minimum value This function calculates the minimum value of the force curve. If this is performed after the Baseline operation, this gives a measure of the maximum adhesion. The Minimum function displays the lowest value read from the curve along with the position information. This operation is designed to be used after the Baseline operation, as shown here, where the zero force level has already been set. In this case, the Minimum function gives a measure of the maximal adhesion (in this case 82.02 mV). If this operation is used on a force curve where the deflection has been calibrated in Newtons, then the adhesion value here is also in Newtons. The data is read from the Retract channel by default, it can also be set to the Extend channel. DP Data Processing Software Version 4.2 67