Download MegaWin 3.0 Software User Manual

User’s Manual
Measurement list can be sorted according to Person or Project. If Project is selected
then the measurements must be associated to a Project. The options in the
Measurement list area determine the columns that will be displayed in Result
window. For further information see Chapter 11.
5.2.5.2.4 Misc tab
Figure 5-18. Misc tab.
Enable transparent windows by marking Allow transparent windows. Transparent
windows are discussed further in section 15.3.
Click Audio feedback setup… to get to Audio Feedback Setup window.
The audio feedback setup window can be used with online average and trainer
measurements.
Note that you can also modify the audio feedback settings from the Audio
feedback tool window while measuring (see Section 10.3.3). However, you should
keep in mind that it might be difficult to adjust the audio settings while measuring.
TE!
NO
To be able to hear audio feedback you must close all other programs which are
using wave sound interface (e.g. media players, games etc.).
The Sounds tab
The Audio Feedback Setup window contains controllers for 5 parallel Wave
sounds (8-bit), which can all be played simultaneously. The sound located between
the red line and the blue line is a continuous sound to be played within the signal
limits. Continuous sound is played with its frequency changing in relation to the
signal level, thus giving an indication on its strength.
Above the upper and below the lower limits lines (blue and red) there are on each
side two sound channels: Continuous sound and Exceed / Falling under message sound.
The later is to be played once, each time the signal has exceeded upper limit or fell
 Mega Electronics Ltd 2010
54