Download SNAP PAC MOTION CONTROL USER'S GUIDE

Transcript
CHAPTER 5: COMMAND REFERENCE
Name
Profile segment
OptoScript
Example
See Also
Bits
Description
13-15
When the profile mode is S-curve, it contains the profile segment
number 1-7 while profile is in motion, and contains a value of 0 when
the profile is at rest. This field is undefined when using the Trapezoidal and Velocity Contouring profile modes.
Status=TransmitReceiveString
(“>GetActivityStatus,2”,ComHandle,ResponseString)
GetEventStatus (page 47), GetSignalStatus (page 52)
SNAP PAC Motion Control User’s Guide
41
41