Download N6700 User's Guide
Transcript
2 Installation Channel Number The channel number of a power module is determined by the location of that module in the mainframe. When viewed from the rear, the module next to the GPIB connector is always output channel one. Numbering continues sequentially to the left, from one to four. If there are less than four modules, channel numbering corresponds to the actual number of installed power modules. Unused channel slots must contain filler modules to ensure proper airflow for cooling. Double-wide power modules are assigned the channel number of the lowest numbered slot in which is installed. For example, if a doublewide module is installed in slots 3 and 4, it is assigned channel number 3. NOTE Power modules that are connected in parallel and have been configured or grouped to act as a single, higher-power channel are addressed using the channel number of the lowest channel in the group. 400 Hz Operation Redundant Ground Requirement At 400 Hz AC input operation, the leakage current of the unit exceeds 3.5 mA. This requires the installation of a permanent, redundant ground from the instrument chassis to earth ground. This ensures that ground will always be connected and that any leakage current will be diverted to ground. Refer to the Service Guide for installation instructions. Power Factor At 400 Hz AC input operation, the unit’s power factor is affected as follows: Under full load at 400 Hz, power factor drops from 0.99 (@120 VAC) to as low as 0.76 (@ 265 VAC). Power factor degrades further under no load conditions. Cleaning WARNING SHOCK HAZARD To prevent electric shock, unplug the unit before cleaning. Use a dry cloth or one slightly dampened with water to clean the external case parts. Do not attempt to clean internally. 28 Series N6700 User’s Guide