Download 223 Sample Changer User's Guide

Transcript
Maintenance
When moving the sample changer:
1
Re-install the arm locking screw using the
following procedure. Refer to the diagrams on
page 2-7 if necessary.
a) Turn off the sample changer.
b) Move the horizontal arm to the right as far as
it will go.
c) Locate and remove the arm locking screw
from its storage location on the rear panel.
Transporting the Sample Changer
Transporting the Sample Changer
4
d) Remove the plastic plug located on the right
side panel.
e) While holding the horizontal arm in its far
right position, install the arm locking screw
into place inside the sample changer.
f) Replace the plastic plug.
2
Lift the sample changer by grasping the base. Do
not use the horizontal arm as a handle.
4-7