Download 223 Sample Changer User's Guide
Transcript
Maintenance When moving the sample changer: 1 Re-install the arm locking screw using the following procedure. Refer to the diagrams on page 2-7 if necessary. a) Turn off the sample changer. b) Move the horizontal arm to the right as far as it will go. c) Locate and remove the arm locking screw from its storage location on the rear panel. Transporting the Sample Changer Transporting the Sample Changer 4 d) Remove the plastic plug located on the right side panel. e) While holding the horizontal arm in its far right position, install the arm locking screw into place inside the sample changer. f) Replace the plastic plug. 2 Lift the sample changer by grasping the base. Do not use the horizontal arm as a handle. 4-7