1
Download ECN330-switch User Guide
Transcript
Command Line Interface Command Usage This command displays the global DVMRP settings described in the preceding pages: • Admin Status, router dvmrp, (section 7.27.3 on page 1108) • probe-interval (section 7.27.4 on page 1110) • nbr-timeout (section 7.27.5 on page 1111) • flash-update-interval (section 7.27.7 on page 1112) • prune-lifetime (section 7.27.8 on page 1113) • report-interval (section 7.27.6 on page 1112 • default-gateway (section 7.27.9 on page 1114) • ip dvmrp metric (section 7.27.11 on page 1116) Example The default settings are shown in the following example: Console#show route dvmrp Admin Status Probe Interval Nbr expire Minimum Flash Update Interval prune lifetime route report Default Gateway Metric of Default Gateway Console# 7.27.14 : : : : : : : : enable 10 35 5 7200 60 0.0.0.0 1 show ip dvmrp route This command displays all entries in the DVMRP routing table. Command Mode Normal Exec, Privileged Exec 1118 1553-KDU 137 365 Uen D 2006-06-16
