Download Micro-Master 4500 Plus User Guide Introduction Micro

Transcript
Micro-Master 4500 Plus User Guide
Multiple starts in Chronological order.
Up to nine starts for each of the programs 1 to 8 can be displayed and sorted into Chronological
order.
Pump Off Delay ( 0 - 99 seconds)
May be necessary if slow turn off valves are used.
Delay Before Hold. ( 0 - 99 seconds )
If a pressure or flow sensor is connected across the HOLD input, it can be in the active state at
the start of irrigation. To mask this input, the HOLD DELAY can be set to ignore the HOLD
input for the period of HOLD DELAY.
Inter-Station Delay ( 0 - 99 seconds )
For some valves to switch off, full pressure must be applied to the valve. To ensure this, a delay
is inserted between one valve switching off and the next valve switching on.
Cyclic Irrigation.
Each program can have 1 – 99 cycles. ( 0 cycles = no irrigation).
Next Program to start,
4500+25 001 SUN W1
CHEM PRG 5 TUE W1
12:35
06:35
Next program to start is program 5 with Chemical injection on Tuesday week 1 at 06:35.
Totalizer
The total of the irrigation and Chemical injection time for each station is displayed. The totals can
be set to zero at any time.
Water budget
Adjustment range of 0% to 250% for each program.
Global Rain ON/OFF
Can disable OR enable all programs with Global rain switch.
Permanent memory.
A back-up battery is installed only to retain the clock during power failure.
Auto-Skip delay
Auto-Skip 1 time at the beginning of irrigation and during station change. It then reverts to the
Auto Skip 2 time. (0 – 255 seconds).
Time-Zone
Set a time “window” for irrigation to operate within. This enables the user to optimise power
costs and water when available.
Fault Reporting.
Monitors flow or pump pressure using two preset auto-skip times. In the case of a malfunction,
the controller will log the faulty station, and then step to the next station. The faulty stations can
be recalled at any time. The fault will be logged with a W to indicate a watering error has
4
Rev.0310