Download User Installation manual
Transcript
*screw up power wire. * Check max. value of power requirement. If you intend to merge power supply of electric lock of the door together with this RFID access control kit from one source, please check fuse unit in the relay box or directly upgrade the fuse to 2A. <see J3, J2 & FS1 as below> z Alternatives to link with the interface on Electric lock? Please check the wiring instruction of the electric lock. Then, you can reference the wiring example as below: Electric Lock; Strike SAMPLE 1 NC CM NO J3 J2 +12V DC GND Relay Box (open case) *All cables wire through the hole on back case. Electric Lock; Strike SAMPLE 2 NC CM J2 NO J3 +12V DC GND Relay Box (open case) *All cables wire through the hole on back case. - 10