Download installation manual

Function 59 Backup Account Number
Default Nil
Notes:
1.
See function 70 for details of Securitel line fail backup to GSM or dialler
2.
4 Digits Limits 0000- 9999
3.
This backup account number is used only when programmed for Securitel (Function 67=9)
and line fail detection is enabled with a Line Fault Monitor and connected into section 16
and programmed as per function 70
Key Sequence
2 1 8 0 6 7
5 9
6 6 6 6 On
Off
On
Operation
Enter valid Technician code.
Select function 59
Enter Backup Account number - example 6666
Exit Program mode
Function 60 Account Number / HID
Notes:
1.
2.
3.
4.
5.
Default Nil
4 Digits Limits 0000- 9999
This function is used to enter the account number for transmission to the Central Station.
The dialler will not dial if account number or phone number not programmed.
When Option 67 is set to 3 then area 1 uses this Account Number , area 2 uses Account
Number +1, area 3 uses Account Number +2, area 4 uses Account Number +3 etc.
This Account number is the Hard I.D. when programmed for Securitel (Function 67=9)
Key Sequence
2 1 8 0 6 7
6 0
6 6 6 6 On
Off
On
Operation
Enter valid Technician code.
Select function 60
Enter Account number - example 6666
Exit Program mode
Function 61 Day Local Sections
Default Nil
Display and change which sections will operate as local sections. In Day mode these sections will not
report an alarm back to the Central Station. Sirens, Strobe and outputs 1-3, depending on options
55,56,81,82,83.
Day Mode is when the area is disarmed.
Key Sequence
2 1 8 0 6
6 1
7
On
06
On
Off
Operation
Enter Tech code (default 218067)
Select Function 61
(previously selected sections will flash)
Section 6 is selected for day local
Store this selection
Exit program mode
Function 62 Download Phone number
Default Nil
Note:
The phone number may be up to 15 digits long Including pauses
1 sec pause = Partial key.
Key Sequence
2 1 8 0 6 7
6 2
047 Partial 218067
On
Off
(C) Copyright 2002
On
MCM Electronics Pty Ltd
Operation
Enter valid Technician code (default 218067 ).
Select function 62
e.g. shows 047 pause 218067
Store Entry
Exit Program mode
Page 18