Download LightSYS User Manual
Transcript
Mastering Your System SMS messaging and/or mobile email requires the use of the LightSYS GSM/GPRS module. Email messaging (via ADLS/Cable connection) requires the use of the LightSYS IP module. Keypad Indication The LightSYS LCD keypad is the primary system interface and reports its status via its LCD icons, as described below. Keypad LCD Icons Power Ready Set Part Set / Omit Tamper Fire On System is operating properly from AC power, its backup battery is in good condition and there are no faults in the system. Off No power. Slow Flash System is being programmed. Rapid Flash System fault. On System is ready to be set. Off System is not ready to be set Slow Flash System is ready to be set while exit/entry zone is open. On System is set in Full Set or Part Set mode. Off System is unset. Slow Flash System is in Exit Delay. Rapid Flash Alarm condition. On System is in Part Set or Zone Omit mode. Off No omit zones in system. On Zone/keypad/external module has been tampered. Off All zones are operating normally. On Fire alarm. Off Normal operation. Flashing Fire zone problem. LCD Status Display The LCD status display will vary depending on the number of partitions in your system. If your system is defined with only one partition, the LCD displays the partition name, time and date. Page 9 LightSYS User Manual