Download LightSYS User Manual
Transcript
Mastering Your System System Monitoring Report to Alarm Receiving Center When a system event occurs, the control system sends a message to your monitoring service describing the exact nature of the event. This enables the monitoring service to perform the required action. Monitoring service notification can be implemented through either regular telephone cellular communication or IP network. A sensor detects. The control system is alerted. An alarm is generated and the monitoring service is notified. Caution: Remember that no security system can prevent emergencies. This system is only intended to alert you in case of an emergency and should not take the place of prudent security practices or life and property insurance. Follow Me Messaging In the case of an alarm or event, the system can initiate a report message to up to 16 predefined designated destinations using a voice announcement, SMS or email to express the active event. SMS Example: Email Message Example: Security System: 21/01/2011 Intruder Alarm Partition 1 Entrance Subject: Alarm Security Message: Intruder Alarm System Name: John's Residence Event: Fire Alarm, Zone 5, Entrance door Time: 01 April 2011; 16:12 Partition: Partition 1, First floor Service Contact: Alarm Receiving Center 01, 035676778 Your engineer defines the type of reporting to a Follow Me destination. Consult your engineer for the report type for each destination. The definition of the telephone number or Email address for each destination is defined by the grand master (see page 31) Notes: Voice messaging requires using the LightSYS voice module. This module also enables the LightSYS to announce various local messages to residents. LightSYS User Manual Page 8