Download LightSYS User Manual

Transcript
Mastering Your System


SMS messaging and/or mobile email requires the use of the LightSYS GSM/GPRS
module.
Email messaging (via ADLS/Cable connection) requires the use of the LightSYS IP
module.
Keypad Indication
The LightSYS LCD keypad is the primary system interface and reports its status via its
LCD icons, as described below.
Keypad LCD Icons
Power
Ready
Set
Part Set / Omit
Tamper
Fire
On
System is operating properly from AC power, its
backup battery is in good condition and there are no
faults in the system.
Off
No power.
Slow Flash
System is being programmed.
Rapid Flash
System fault.
On
System is ready to be set.
Off
System is not ready to be set
Slow Flash
System is ready to be set while exit/entry zone is
open.
On
System is set in Full Set or Part Set mode.
Off
System is unset.
Slow Flash
System is in Exit Delay.
Rapid Flash
Alarm condition.
On
System is in Part Set or Zone Omit mode.
Off
No omit zones in system.
On
Zone/keypad/external module has been tampered.
Off
All zones are operating normally.
On
Fire alarm.
Off
Normal operation.
Flashing
Fire zone problem.
LCD Status Display
The LCD status display will vary depending on the number of partitions in your system.
If your system is defined with only one partition, the LCD displays the partition name,
time and date.
Page 9
LightSYS User Manual