Download Wizard Plus V3 Operating Instructions

WIZARD PLUS – Edit / Delete Transducer
Ensure that the correct Transducer is selected before
Editing or Deleting.
Edit Transducer
•
From the WIZARD PLUS Menu select Config then
Transducer. A password may be required at this
point.
•
From the Transducer menu choose Edit then
select the required transducer from the list of
those configured.
•
All details may be edited with the exception of
the Serial Number. If the Serial Number needs
to be changed, the Transducer must be deleted
and re-entered.
•
On the Transducer Configuration screen, the
Sensitivity (mV/V) can be edited. This may be
necessary following a re-calibration.
•
Press Cancel to cancel changes or Save to
update the information.
Delete Transducer
Select Delete on the Transducer Configuration screen.
•
All data relating to the selected transducer will be deleted.
•
If the currently connected transducer is deleted a message will
be displayed and WIZARD PLUS will be set to ‘None
Selected’.
•
A transducer must be selected before WIZARD PLUS can be
used again.
3.4