Download Rectifier PSS18 USER MANUAL

Transcript
Primary Switch Mode Rectifier
PSS18
User manual
Page 20 (28)
Signals (connector X4 = 15 x COMBICON 1.5mm2):
Pin assignment of X4 for PSS18/220V with signalling relay (without CAN-Bus)
X4, pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Function
(+) external switch on/off 4)
(-) external switch on/off
optocoupler emitter
optocoupler collector "Mains O.K."
optocoupler collector "VO O.K."
optocoupler collector "IO"
BUS ground
signal input discharge test mode / boost charge mode 1)
temperature sensor (+) 2)
control wire for current sharing mode 3)
relay contact V< , NO 5)
relay contact collective failure , NO 5)
relay contact collective failure , COM
relay contact collective failure , NC 5)
relay contact V< , COM
Pin assignment of X4 for PSS18/220V with CAN-Bus (without signalling relay)
X4, pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Function
(+) external switch on/off 4)
(-) external switch on/off
optocoupler emitter
optocoupler collector "Mains O.K."
optocoupler collector "VO O.K."
optocoupler collector "IO"
BUS – GND
signal input discharge test mode / boost charge mode 1)
temperature sensor (+) 2)
control wire for current sharing mode 3)
CVCC +
CAN-H
CAN-L
CVSS Not connected
REMARK: The legend of the items 1) … 6) follows on the next page.
Eltek Valere Deutschland ©2008
UM_PSS18_E_R02