Download Rectifier PSS18 USER MANUAL
Transcript
Primary Switch Mode Rectifier PSS18 User manual Page 20 (28) Signals (connector X4 = 15 x COMBICON 1.5mm2): Pin assignment of X4 for PSS18/220V with signalling relay (without CAN-Bus) X4, pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Function (+) external switch on/off 4) (-) external switch on/off optocoupler emitter optocoupler collector "Mains O.K." optocoupler collector "VO O.K." optocoupler collector "IO" BUS ground signal input discharge test mode / boost charge mode 1) temperature sensor (+) 2) control wire for current sharing mode 3) relay contact V< , NO 5) relay contact collective failure , NO 5) relay contact collective failure , COM relay contact collective failure , NC 5) relay contact V< , COM Pin assignment of X4 for PSS18/220V with CAN-Bus (without signalling relay) X4, pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Function (+) external switch on/off 4) (-) external switch on/off optocoupler emitter optocoupler collector "Mains O.K." optocoupler collector "VO O.K." optocoupler collector "IO" BUS – GND signal input discharge test mode / boost charge mode 1) temperature sensor (+) 2) control wire for current sharing mode 3) CVCC + CAN-H CAN-L CVSS Not connected REMARK: The legend of the items 1) … 6) follows on the next page. Eltek Valere Deutschland ©2008 UM_PSS18_E_R02