Download USER'S GUIDE

destruction of part or all of the product. Do not proceed beyond a CAUTION sign until the
indicated conditions are fully understood and met.
Introduction
IT8700 DC electronic loads are multichannel programmable electronic loads. With
RS232 /GPIB /USB/ EtherNet communication interfaces, the series DC electronic loads
can provide multi solution according to the requirements of your design and test. IT8700
DC electronic loads provide you with the flexibility to test a wide range of applications
from multi-output AC/DC power supply, DC/DC converter, charger to power electronic
components. It is configured by plugging the user selectable modules into the
mainframe, and operated using the keypad and rotary knob on the front panel or the
remote controlled instructions via Ether Net, USB, RS-232C or GPIB interface. The high
resolution voltage(0.1mV), current(0.01mA) measurement system(Up to 1k Hz
sampling ) provides both accuracy and convenience. User can simulate a wide range of
dynamic loading (Up to 25K Hz) applications. The loading waveform is user
programmable in slew rates, load levels, duration and conducting voltage.
Removable channels: increase system flexibility
Dynamic Power distribution function for dual channels, save your cost
Dual-channel module can display every channel information simultaneously with no
need to switch
Measure peak current in short-circuit
Transient mode: Up to 25KHZ; List mode : 100KHZ
Measurement resolution: 0.1mV,0.01mA
Measurement speed: up to 1KHZ
A unit with single mainframe can take up to 8 channels, with extended mainframe up
to 16 channels
Adjustable slew rate
Support several electronic loads working at the same time
Auto-test function
Output resolution up to 16 bits ,voltmeter and ammeter reach 5 1/2 digits
Constant current(CC),constant voltage(CV),constant resistance(CR) mode
Highlight VFD display for both mainframe and load modules
Support USBTMC/SCPI communication protocol
Output terminals on the rear panel make wiring easy and keep front panel clean
Simulate the transient response and export measured values in time
Built-in waveform generator and LIST mode
Ethernet ,GPIB ,USB ,RS232 interfaces
6