Download USER'S GUIDE

On
The electronic load will measure input voltage from the
remote sense connector.
Off< Default >
The power supply will measure input value from the
front panel connector.
ShortCut Recall
Quickly recall the data stored before
On
Enable this function
Off<Default>
Disable this function
OVP Set
Setting over voltage protection
On
Enable this function
Off< Default >
Disable this function
Meter Rate Set
Setting the speed of power supply
High
High speed
Low< Default >
Low speed
Baudrate set
Setting baud rate
Baudrate
4800
<
Default >
Baudrate 9600
Baudrate 19200
Baudrate 38400
Comm. Parity
Communication parity bit set.
None< Default >
Even
Odd
Address Set
Setting communication address(range from 0to 254)
Address=＊＊
＊＊
Port Mode
Select function of port
Trigger< Def >
RI/DIF
DIGITAL I/O
Trig Source
Setting trigger mode
Immediat<Def>
Trigger signals from Shift + Trigger key
External
Trigger signals from the TRIG connector in the rear
panel.
Bus
Communication command trigger mode.
RI Mode
Control the output mode
Off< Default >
Disable this function
Latching
Live
DFI Source
Discrete Fault Indicator
Off< Default >
QUES
Question Bit
OPER
Operation Bit
ESB
Event State Bit
RQS
Require Bit
Key Lock Set
Setting keypad password.
Press ENTER directly to disable the key lock function.
Password= ﹡﹡﹡﹡
Exit
21