Download JBL SYNTHESIS SDP-45 SURROUND PROCESSOR USER GUIDE

Getting Started
JBL SYNTHESIS SDP-45
PRODUCT REGISTRATION
Please register the SDP-45 Digital Controller within 15 days of purchase.
Register online at www.jblsynthesis.com. Retain the original sales receipt
as proof of warranty coverage.
DO NOT stack the SDP-45 directly above heat-producing equipment
such as a power amplifier.
CAUTION!
Before moving the SDP-45, power the unit off by disconnecting the
power cord from the rear panel and the wall outlet.
INSTALLATION CONSIDERATIONS
The SDP-45 requires special care during installation to ensure optimal
performance. Pay particular attention to instructions below and to other
precautions that appear throughout this user guide.
DO install the SDP-45 on a solid, flat, level surface such as a table or
shelf. The SDP-45 can also be installed in a standard 19-inch equipment
rack using an optional rack-mount kit available from an authorized
dealer.
INCLUDED ACCESSORIES
Installation, Operation and Owners Guide
IEC Standard Power Cord
Remote Control and remote control batteries
UNPACKING
DO select a dry, well-ventilated location out of direct sunlight.
DO NOT expose the SDP-45 to high temperatures, humidity, steam,
smoke, dampness or excessive dust. Avoid installing the SDP-45 near
radiators and other heat-producing appliances.
Your SDP-45 was carefully packed at the factory to protect against any
damage in shipping and handling. Carefully examine the packing and the
unit for any signs of external damage or impact and report those to your
dealer or JBL prior to using the unit. JBL advises that you keep all
packaging in the event that the unit may have to be returned for service.
DO NOT install the SDP-45 near unshielded TV or FM antennas, cable
TV decoders, or other RF-emitting devices that might cause interference.
DO NOT place the SDP-45 on a thick rug or carpet, or cover the
SDP-45 with a cloth, as this might prevent proper cooling.
DO NOT place the SDP-45 on a window sill or any location exposed to
direct sunlight.
DO NOT obstruct the front-panel IR receiver window. The remote control
must be in line of sight with the IR receiver for proper operation.
DO NOT install the SDP-45 on a surface that is unstable or unable to
support all four feet, unless it is installed in an equipment rack.
- 10 -
SAFETY
It is important that you read and completely understand the safety
instructions and warning on page one of this manual before installing or
connecting the SDP-45 to any electrical power source