Download GATE - LITE USER MANUAL

Transcript
ENGLISH
NOTE: only lap 0 will appear as long as a track has not been applied to the session to be
analysed. Once this operation has been executed the division of the laps will be undertaken:
this division will be memorised and made available in later accesses to the same session.
Remember that the times on the lap are influenced by the position of the finish line applied to
the session: in the case that one has official chronometric times and you wish to compare
these properly with those provided by MX2 LITE, it is necessary select a track with a finish
line as close as possible to that actually used by the circuit transponder.
The same consideration prevails, obviously, even during the use of the MD60LOG unit: the
lap time visualised by the unit, in this case as well, depends upon the position of the finish
line of the track used.
•
The channels acquired are now available in the software MX2 LITE analysis area:
ANALYSIS
CURSOR
TABLE OF
CHANNELS VALUE
Y AXIS
INTERMEDIATE
X AXIS
CIRCUIT MAP
•
42
It is possible to display or hide the acquired channels by opening the Channel Bar in MX2 LITE
User Manual GATE-LITE rev. 02
Copyright ©2010 GET by Athena Evolution srl. All rights reserved