Download Density_2 user manual
Transcript
21 Dynamic compressor is a dual-band fully-featured signal compressor with limiting, gating, side-chain. on/off bypass dynamic compressor; enable/disable meters, these values describe the current state of various internal gain levels of the compressor: • compressor gain (left, right); • noise gate gain (left, right); • limiter gain (left, right) The last two right menùs on the right sets • limiter response mode: punchy or smooth. Punchy response yields extremely short attack and release times, useful for transparent limiting, or to create loudness. However, if over-used, intermodulation distortion may result. Smooth response uses longer attack and release times. The result is still a fast lookahead limiter, but with less intermodulation distortion and less punch. • the most right chose one of build presets for the dynamic processor: Guitar, Bass, Vocal, Drums and Program Material - An attempt at smooth "gain riding" of mixed program material as well as can be done with a non-multi-band processor. threshold sets the compressor threshold (in dB below full scale). This is the main compression threshold. Any signal above the threshold will be reduced, and any signal below the threshold will be amplified, according to the range and ratio parameters; ratio sets the numerator of the compressor gain reduction ratio, from 1:1 to Infinite:1; attack sets the rate at which the compressor is engaged when the signal level exceeds the Threshold. The value range is 0-150 on a logarithmic scale, with larger values indicating faster attack; release sets the rate at which the compressor releases its gain adjustment when the signal level no longer exceeds the Threshold. The value range is 0-150 on a logarithmic scale, with larger values indicating faster release. This rate can be modified by the release gate and freeze thresholds. • VST slots