Download SXR User Guide

Transcript
Fig 17: Wire render of a track section plan
In the drawing above we've set the major grid lines to 30cm and we've set a section of track onto
an MDF board.
You can set the gridlines to any spacing you like by going to > View >
Preferences > Grid rotation settings
Example 4 - CAD
Ultimate Racer is also capable of exporting DXF files which can then be imported into a CAD
program.
To export to a CAD program, go to > File > Save as, then changs Save as type to
CAD files (*.dxf)
Conclusion
So that's about all for now, the rest is up to you. I'm sure the information here will be incomplete
in some areas and I'm sure each person will find their own way of doing things. What I've presented
here are just some of my principles, some examples and some ideas, nothing more.
I should make it clear that I have no vested interest in Ultimate Racer, I have devepoed this system
partly for my own use, but mostly for the benefit of the the slot community. I'm a designer by
trade and by conviction, if that makes sense. So, if any of this project helps, even in some small
way, to raise the general standard of the way that scratchbuilt slot tracks are designed and
presented, then I will be a happy man.
26