Download SXR User Guide
Transcript
to get the arc centre. From the inside (red) lane we have Half a Lane Width 4cm + Inside Radius 54 cm = 58cm. Now, going back to the right hand end of the straight we can mark in the section which has two C22-30 curves followed by an S25 straight followed by two more C22-30 curves. Which just leaves us with our final short straight which had a slight overlap on our track plan. This is now of no concern as we can simply connect the two corners with a straight, it doesn't matter how long it is. Most track plans will have a point where things do not exactly join up, but this just means a bit of fiddling about with the exact position of the last corner or straight, it shouldn't be a problem. Obviously most tracks will not fit onto a single sheet of MDF, so it's likely that you will end up working across two or more sheets, but the principles are exactly the same. Having marked out the centres of each curve, you can use the same centre points to rout the slots using a router fitted with a radius arm. 23