Download AntiLog RS232 Data Logging System User Guide

Transcript
PC, PDA or other
RS232 host
RS232 NULL modem cable
AntiLog
Figure 8: Playback configuration
If the cable is not correct, or the host machine (e.g. a PC) is not configured to the baud rate
and data bits which exactly matching the AntiLog settings then successful communication will
not be possible.
When dual serial port playback is required, the 'V' or 'Y' lead can be used to provide the two
serial port outputs from the single AntiLog connector on the end panel.
PC, PDA or other
RS232 host
PC, PDA or other
RS232 host
RS232 NULL
modem cable
RS232 NULL
modem cable
Primary serial port
'Y' Lead
AntiLog
Secondary serial port
Figure 9: Dual serial port playback
5.6 Turning Your Unit Off
To turn off AntiLog at any time, press and hold the 'Off' button for at least a second. You will
see both red and green LED segments light up simultaneously for a brief period indicating the
shut down request has been actioned. It is not possible to turn off the unit by briefly touching
the 'Off' button. This feature helps prevent accidental shut down events which could be
caused by knocking into the buttons in a trials environment.
5.7 User Equipment Commands
V4.0 allows you to define up to four user equipment commands which can be transmitted to
connected equipment in record mode. For a given recording channel, you can assign a user
equipment commands to the 'On' and 'Off' buttons and/or assign one to the channel's polling
feature. In this way, you are able to poll equipment periodically for measurements (e.g. from a
power meter) and issue commands such as equipment reset or configuration requests using the
'On' and 'Off' buttons during record. Section 11.2 describes the User Equipment Command
system in more detail.
Note that there is a maximum four user equipment commands shared across both recording
channels. If you change the definition of a user command, it may effect both channels.
5.8 Digital Bit State Logging
V4.0 introduces the ability to log the state of selected digital input lines on AntiLog and insert
these as events or messages in a channel's log file. This may help you log the status of one or
more discrete line outputs from your equipment.
DOC/AntiLog/UG/2003001_4.0e
Page 17 of 71