Download AntiLog RS232 Data Logging System User Guide

Transcript
bits_per_char = In the range 5 to 8.
parity = N for NONE, E for EVEN or O for ODD.
stop_bits = 1 or 2
rts = R for RTS/CTS hardware handshake, - for None.
Example:
115200,8,N,1,-
If the Dual Serial Port option is enabled, the serial port format is extended as follows:p:baud_rate,bits_per_char,parity,stop_bits,rts
where:
p = M for main serial port, P for secondary serial port.
Example:
M:115200,8,N,1,-
13.1.1 Recording port settings
The following is an example of the Recording port settings for dual channel recording:Record
Ch1 = M:
Ch2 = S:
4800,8,N,1,- (Filtered NMEA,AscTStamp,Buttons)
9600,8,N,1,- (ASCII Line sub sample,PollFn)
Note that hardware handshaking (RTS) is not required for recording and so this element of the
port setting output is always '-'. The feature codes in brackets can be any one or more of the
following:Text Code
Description
Record All
Records all incoming data without any data filtering
Filtered NMEA
Records only selected ASCII NMEA sentences
ICD-GPS-15x
Records ICD-GPS-15x compatible data
ASCII Line sub sample
Record using ASCII line sub sampling
AscTStamp
Embed time stamps into data stream by removing data byte top bit.
8BitTStamp
Embed time stamps into data stream allowing full 8 bit binary
recording
NByteTStamp
Embed a time stamp before every 'N' bytes of data
MsgTStamp
Insert time stamp messages into recording stream
PollFn
Polling function has been activated for this recording channel
Buttons
At least one button event has been activated for this recording
channel
13.1.2 Playback port settings
The following is an example of the Playback port settings for dual channel playback:Playback Ch1 = M:115200,8,N,1,- (Real Time,SessionHdr,TStamp)
Ch2 = S:115200,8,N,1,- (Hexadecimal Dump,SessionHdr)
DOC/AntiLog/UG/2003001_4.0e
Page 54 of 71