Download AntiLog RS232 Data Logging System User Guide
Transcript
PC, PDA or other RS232 host RS232 NULL modem cable AntiLog Figure 8: Playback configuration If the cable is not correct, or the host machine (e.g. a PC) is not configured to the baud rate and data bits which exactly matching the AntiLog settings then successful communication will not be possible. When dual serial port playback is required, the 'V' or 'Y' lead can be used to provide the two serial port outputs from the single AntiLog connector on the end panel. PC, PDA or other RS232 host PC, PDA or other RS232 host RS232 NULL modem cable RS232 NULL modem cable Primary serial port 'Y' Lead AntiLog Secondary serial port Figure 9: Dual serial port playback 5.6 Turning Your Unit Off To turn off AntiLog at any time, press and hold the 'Off' button for at least a second. You will see both red and green LED segments light up simultaneously for a brief period indicating the shut down request has been actioned. It is not possible to turn off the unit by briefly touching the 'Off' button. This feature helps prevent accidental shut down events which could be caused by knocking into the buttons in a trials environment. 5.7 User Equipment Commands V4.0 allows you to define up to four user equipment commands which can be transmitted to connected equipment in record mode. For a given recording channel, you can assign a user equipment commands to the 'On' and 'Off' buttons and/or assign one to the channel's polling feature. In this way, you are able to poll equipment periodically for measurements (e.g. from a power meter) and issue commands such as equipment reset or configuration requests using the 'On' and 'Off' buttons during record. Section 11.2 describes the User Equipment Command system in more detail. Note that there is a maximum four user equipment commands shared across both recording channels. If you change the definition of a user command, it may effect both channels. 5.8 Digital Bit State Logging V4.0 introduces the ability to log the state of selected digital input lines on AntiLog and insert these as events or messages in a channel's log file. This may help you log the status of one or more discrete line outputs from your equipment. DOC/AntiLog/UG/2003001_4.0e Page 17 of 71