Download MX7 User's Guide - English
Transcript
Quick Start In Brief . . . Note: When your mobile device is pre-configured, the client, keypad and scan aperture configurations are assembled by LXE to your specifications. The desktop will display an Odyssey Client Utility icon or it will display a Summit Client Utility icon. This section’s instructions are based on the assumption that your new device is pre-configured and requires only accessory installation (e.g. stylus) and a power source. LXE recommends that installation or removal of accessories be performed on a clean, well-lit surface. When necessary, protect the work surface, the mobile device, and components from electrostatic discharge. This guide takes you through an introduction to and operation of the MX7. 1. 2. 3. 4. 5. Insert a fully charged main battery pack. (Always put a fully charged battery in the mobile device at the beginning of the shift or workday.) Connect an external power source to the unit (if required). If the screen does not automatically display, tap the Power key. Calibrate the touchscreen (OS versions released before August 2008 only). A white screen will appear during the boot process until all CAB files and applications are loaded and installed. Radio setup screens may appear and disappear while files are loading. After all files are loaded and the Desktop is displayed, adjust audio volume and other parameters if desired. If needed, change the Time and Date from it’s default value by tapping the Panel | Date/Time icon. MX7 with Odyssey Client | Settings | Control MX7 with Summit Client Figure 9 MX7 Desktop Based on your installed software version and hardware options, your system may not be exactly the same as the system described in this guide. Contact your LXE representative for information on the latest upgrades for your MX7. E-EQ-MX7OGWW-J MX7 User’s Guide