Download Thermolator heaTrac User Guide

SELECTING THE
TEMPERATURE
CONTROL POINT
(TH-2
8
ONLY)
Press the RUN button to save the control point.
◆ The control will display “Pr OFF” to prompt you to
remove power to the unit.
IMPORTANT: If RUN is not pressed, the new
control point source will not be saved.
9
10
Turn off power to the unit. Disconnect and lock out
the main power supply.
Open the electrical
enclosure.
8 7 6 5 4 3 2 1
11 Set dip switch 5 to
OFF.
12 Close the electrical enclosure and restore
power to the unit.
The TH-2 will now control the process temperature based
on actual temperatures recorded at the new control point
source.
UGH002/0514
Thermolator heaTrac TH-1 and TH-2 control
INSTALLATION
3-13