Download Installation and Operating Instructions Einbau
Transcript
7. Installation of the sectional door 7.1 Checking the dimensions GB Attention: Prior to installation, please check whether the supplied door is suitable for the proposed installation site. Carry out the following measurements on the inside of the door opening (fig. 7.1): A Clearance width at the top and bottom of the door opening. The supplied opening dimensions have to correspond to the door clearance width. B Clearance height on the right and left-hand side of the door opening. The supplied opening dimensions have to correspond to the required door clearance height. C Headroom on the right and on the left-hand side above the door opening. – The headroom has to be at least 115 mm (for doors with electric drive). – The headroom has to be at least 140 mm (for very large doors with electric drive and 4x spring duct). – The headroom has to be at least 240 mm (for manually operated doors with exterior handle). – The headroom has to be at least 265 mm (for very large manually operated doors with exterior handle). D The sideroom on the right and left-hand side of the door opening has to be at least 82.5 mm. Operational check: If all 4 requirements have been fulfilled, start installation. Please see the order form for the opening dimensions. 9