Download Installation and Operating Instructions Einbau

Transcript
7.
Installation of the sectional door
7.1
Checking the dimensions
GB
Attention:
Prior to installation, please check whether the supplied door is suitable for the
proposed installation site.
Carry out the following measurements on the inside of the door opening (fig. 7.1):
A
Clearance width at the top and bottom of the door opening.
The supplied opening dimensions have to correspond to the door clearance width.
B
Clearance height on the right and left-hand side of the door opening.
The supplied opening dimensions have to correspond to the required door
clearance height.
C
Headroom on the right and on the left-hand side above the door opening.
– The headroom has to be at least 115 mm (for doors with electric drive).
– The headroom has to be at least 140 mm
(for very large doors with electric drive and 4x spring duct).
– The headroom has to be at least 240 mm
(for manually operated doors with exterior handle).
– The headroom has to be at least 265 mm
(for very large manually operated doors with exterior handle).
D
The sideroom on the right and left-hand side of the door opening has to be
at least 82.5 mm.
Operational check:
If all 4 requirements have been fulfilled, start installation.
Please see the order form for the opening dimensions.
9