Download Installation Manual

7. Disclaimer of Liability
8. Contact Information
......... pag. 16
Annex 1
Installations Using Frame Mounting Holes
Installations Using Pressure Clamps
Insertion Systems
......... pag. 17
......... pag. 16
1.
Nameplate: it is to be found on the module backside. According to EN 50380 Directives it provides information about the main parameters of the module: Product Type, Maximum Power, Current at Maximum
Power, Voltage at Maximum power, Open Circuit Voltage, Short Circuit Current, all as measured under
Standard Test Conditions, weight, dimensions, Maximum System Voltage, Maximum series fuse etc.
Serial number
They are permanently inserted inside the laminate, under the front glass of the module, visible when viewing from the front of the module. There is only one serial number coupled with one barcode on the
module.
2. Safety
2.1 General Safety
All PV modules shall be installed according to all local and national applicable standards, codes and reinjury that might occur during installation including, without limitation, the risk of electric shock. Check
Do not attempt to disassemble the modules, and do not remove any attached
nameplates or components from the modules.
Do not apply paint or adhesive to module top surface.
modules.
Do not expose back sheet foils directly to sunlight.
2