1
Download INSTALLATION MANUAL
Transcript
The MS Speed Master is extremely versatile in its application and therefore it is important that you can identify which model you are working with and what parts of the manual are applicable. When power is switched on, the control panel will show the model information i.e. power, program number and software version. For example: = Speed Master 1.5Kw, Program 15, Version 71 POWER PROGRAM VERSION The Speed Master has been pre-programmed to the value shown in the table when it was originally supplied to reduce installation time. Notes: Serial Number ........................................................... Software Version ........................................................... Program Number ........................................................... Date of Original Supply ........................................................... MODEL IDENTIFICATION MODEL IDENTIFICATION Model type MS 0.75, 230v, 1ph, 0.75kw (max 4.5 amp) .......................................................................................... MS 1.5, 230v, 1ph, 1.5kw (max 7 amp) .......................................................................................... Safety edge type. Selected by Parameter 7** 8K2 conductive edge (7** = 1) .......................................................................................... Opto edge (7** = 2) .......................................................................................... Other .......................................................................................... Limit switch/encoder type. Selected by Parameter 8** Incremental Encoder with reference switch (8** = 2) .......................................................................................... Limit switches (8** = 5) .......................................................................................... Incremental encoder with mechanical stop reference in the open direction (8** = 7) .......................................................................................... Motion/AWG RS 485 Absolute resistor (8** = 9) .......................................................................................... Incremental encoder with reference switch reference run in Dead Man (8** = 10) .......................................................................................... Incremental encoder with mechanical stop reference in the closed direction (8** = 12) .......................................................................................... Other .......................................................................................... Notes: www.motion-systems.co.uk 3
