1
Download Kinetis Quick Reference User Guide
Transcript
Mode transition requirements Table 5-1. Module operation in low power modes (continued) Module STOP VLPR VLPW VLPS LLS VLLSx I2S Static FF FF Static Static OFF Segment LCD FF FF FF FF FF-RTC clk FF-RTC clk TSI Wakeup FF FF Wakeup Wakeup -One pin Wakeup - One pin FTM Static FF FF Static Static OFF PIT Static FF FF Static Static OFF PDB Static FF FF Static Static OFF LPT FF FF FF FF FF FF Watchdog FF FF FF FF Static OFF EWM Static FF Static Static Static OFF 16-bit ADC ADC internal Clk FF FF ADC internal Clk Static OFF CAN Wakeup FF FF Wakeup Static OFF CMP HS or LS FF FF HS or LS LS LS 6-bit DAC Static FF FF Static Static Static VREF FF FF FF FF Static OFF OPAMP FF FF FF FF Static OFF TRIAMP FF FF FF FF Static OFF 12-bit DAC Static FF FF Static Static Static USB-FS/LS Static Static Static Static Static OFF USB DCD Static FF FF Static Static OFF USB DCD Static FF FF Static Static OFF USB Regulator Optional Optional Optional Optional Optional Optional Ethernet Wakeup Static Static Static Static OFF RTC-Ext OSC2 FF FF FF FF FF FF CMP HS or LS FF FF HS or LS LS LS 6-bit DAC Static FF FF Static Static Static VREF FF FF FF FF Static OFF 5.5 Mode transition requirements Table 5-2. Mode transition requirements Trans# 1 From To Trigger Conditions RUN WAIT Execute WAIT(); - This means that sleep-now or sleep-onexit modes entered with SLEEPDEEP clear WAIT RUN Interrupt or Reset Table continues on the next page... Kinetis Quick Reference User Guide, Rev. 2, 08/2012 62 Freescale Semiconductor, Inc.
