Download User Manual - Gill Instruments

Transcript
Operation
3.3.7
Configuring MetPak for MODBUS
MetPak Supported Modbus Specification
MODBUS
RTU or ASCII.
Baud Rate
9600 or 19200 Baud.
COMMS
RS232 point to point only, RS485 2 wire networkable.
Modbus Parameters ASCII or RTU.
Parameter
Character
Error Check
Frame Start
Frame End
Gaps in Message
Start Bit
Data Bits
Parity
Stop Bits
Modbus ASCII
ASCII 0 to 9 and A to F (Hex)
Longitudinal Redundancy Check (LRC)
Character ':' (3A Hex)
Characters CR/LF (0D/0A Hex)
1 Second
1
7
Even/Odd
None
1
2
Modbus RTU
Binary 0 to 255
Cyclic Redundancy Check (CRC)
3.5 Characters Silence
3.5 Characters Silence
1.5 Times Character Length
1
8
Even/Odd
None
1
2
Requires:MetPak with version 2346-4.00 firmware and onwards.
MetSet Software version 2.02-02 and onwards.
Connect a MetPak to a PC COM port (default communication is RS232).
Open Gill MetSet Software.
Click on Connect and Read to reach the Editing Pages as shown below.
Configuration
Click on the MODBUS Page
Mode:
Choose between RTU and ASCII, in this case RTU.
Address:
Choose a MetPak Address number to be between 1 to 247.
Data Bits:
Choose 7 for Modbus ASCII and 8 for Modbus RTU.
Stop Bits:
Choose 1 for Even/Odd Parity or 2 for No Parity.
Parity:
Choose Even/Odd or None.
Termination Char ASCII code:
Choose between 0-255.
Inter Char Timeout (ms):
Choose between 500ms to 10000ms.
MetPak User Manual
© Gill Instruments Ltd
Page 44
Last Change
26 March, 2014