Download HPLA Linear actuator

PLEASE NOTE: THIS IS HAUSER GERMANY MANUAL.
Startup
FOR USA NOMENCLATURE PLEASE GOTO PARKERMOTION.COM
3.3 Installation
Caution
Take care when transporting long actuators. Deflection can badly affect the guidance. Equally, the profile can change and adversely affect the performance of the
carriage.
Note
When the HPLA is being fitted, with the carriage projection upwards, do not remove
the adhesive film until the conclusion of all assembly work in order to avoid dirt
getting into the interior of the HPLA.
Note
When installing the HPLA, make sure there is adequate access to the tensioning
station and the carriage for maintenance purposes! (There have to be enough place
behind the tensioning station to put out the carriage completely).
3.3.1 Installing a single actuator
1. Remove the actuator from the transportation box.
2. Place the HPLA on the levelled connection points (spirit level, levelling instrument).
3. Attach the actuator. To do this, place sliding blocks in the t-slot groove of the profile and
fasten with screws. Do not drill the profile!
4. Attach the add-on accessories.
5. Remove the dust cover (adhesive film).
3.3.2 Installing a dual actuator
1. Remove the actuator from the transportation box.
2. Place the HPLA on the levelled connection points (spirit level, levelling instrument).
3. Attach the actuator. To do this, place sliding blocks in the t-slot groove of the profile and
fasten with screws. Do not drill the profile!
4. Attach the second actuator and fasten loosely.
5. Measure the parallelism (e.g. by tape measure) (see Figure 1).
6. Measure both diagonals to check that it is square (tape measure) (see Figure 1). If
necessary, correct the diagonal measurement by parallel movement of the second actuator.
7. Check the horizontal orientation of both actuators to one another (spirit level, levelling
instrument), and correct if necessary.
8. Finally, fasten the second actuator.
9. Attach the add-on accessories.
10. Remove the dust cover (adhesive film).
=
=
=
=
Figure 1: Aligning a dual actuator
Note
When installing the actuator vertically, the above procedure must be modified
accordingly.
21