Download User's manual

7. Fully automated adjustment of the Display Wall
Use the slider to equally adjust the RGB components of the selected color.
In case you want to further improve the color adjustment, there are three possibilities:
•
Start a second measurement procedure to automatically verify and improve the auto-target. The
homogeneity will further be improved.
•
Perform a manual improvement to change the color and/or luminance of the Display Wall (cf. Fine tuning after
the automated adjustment procedure)
•
Select a user defined target, and apply this to the Display Wall, cf. User-defined targets)
Whenever a target is applied, there is the possiblity of automatic or manual improvement.
7.7 Verifying the auto-target
Let's assume to continue with the automatic adjustment procedure. To continue, select again Wall|Measure.
The view changes to show the adjusted color, and since the color locations had not been verified yet, a question
mark is displayed. However, the measurement cycle indicator already shows a 1.
Figure 7-21
adjusted colors, not measured yet
Click on Measure to start the verification procedure.
Figure 7-22
start measuring
Barco – CAST for OverView D series – DOC-3329-2 – user's manual – Revision 04 – December-2006 ____________________________________ 7-13