Download Optilab rEX User's Guide

Appendix F: Warnings
F.1 List of Warnings
WARNING
If the power cord is connected, line voltages of 120-240 VAC, 50-60 Hz are
present within the system even when the power switch is off. Always disconnect the power cord before opening the instrument cover.
WARNING
High voltage is stored in the instrument power supplies for some time
(hours) after the instrument is switched off and the power cord is disconnected. Under no circumstances should the power supplies be accessed by
unqualified personnel.
WARNING
The Optilab rEX contains a “Class 1 LED Product per IEC 60825-1”,
which is a non-lasing LED coupled to an optical fiber. The LED in this
LED/fiber unit is mounted to the top electronics board in the Optilab rEX
near connector P3. The fiber brings the light from the LED into the optical
system. With the instrument off and the power cable disconnected, it is
safe to replace the LED/fiber unit. The LED/fiber unit should not be
altered or modified in any way.
WARNING
The instrument contains fluid. Under normal operating conditions, the
system may contain up to 0.5 mL of fluid introduced into the system by the
user. If a leak develops internal to the instrument, additional fluid may be
present in the system. The system has been designed to bring fluid leaks
to standard locations within the instrument, but there always exists the
possibility of fluid present in non-standard locations. Fluid introduced into
the instrument by the user or its vapors may be hazardous. Safety precautions appropriate to the fluid within the system should be taken under the
assumptions that the fluid may not reside in standard locations within the
instrument, and may not be contained by the instrument.
F-2
Optilab rEX User’s Guide (M1500 Rev. D)