Download PROGRAMMABLE CONTROLLER FP0R User's Manual

Password
setting
Interrupt
setting
PLC link time
setting
MEWTOCOLCOM
response
control
High-speed
counter
operation
mode
changing
System
registers
“No. 40 to
No. 47”
changing
: Available,
SYS2
*1
FP2
*1
FP2SH/FP10SH
FP-X
Change the communication conditions
for the COM port or tool port based on
the contents specified by the character
constant.
Change the password specified by the
PLC based on the contents specified by
the character constant.
Set the interrupt input based on the
contents specified by the character
constant.
Set the system setting time when a PLC
link is used, based on the contents
specified by the character constant.
Change the communication conditions of
the COM. port or tool port for
MEWTOCOL-COM based on the
contents specified by the character
constant.
Change the operation mode of the highspeed counter, based on the contents
specified by the character constant.
FP0R
Description
FPΣ
Special setting instructions
SYS1
Communication conditions setting
Symbol
FP0/FP-e
Boolean
Steps
Name
*2
13
*3
*3
Change the setting value of the system
register for the PLC link function.
7
: Not available,
: Not available partially
*1) With FP-X Ver2.0 or later, and FPΣ Ver 3.10 or later, the baud rate can be selected from 300, 600 or 1200 bps.
*2) With FPΣ 32k type, the 8-digit password can be selected.
*3) With FPΣ 32k type and FP-X Ver1.10 or later, it can be used.
15-43