Download User manual

Alarm
Handle:
Triggered Camera:
Parameter
Pop-up Image on Monitor
Setting
A message appears on the
monitor.
Audio Warning
The device emits a repeating tone.
Notify Surveillance Centre
Sends an alarm signal to a
PC with ABUS CMS software. The software must be
enabled and the recorder
set to surveillance mode on
the PC.
Send Email
An e-mail is sent to a specific e-mail address (see
page 48).
Trigger Alarm Output
See page 51.
Schedule:
Here you can define in which period of time the reaction
to the alarm input shall be handled.
Parameter
Setting
Record
Using this parameter, you can select
which cameras should be used for recording after the alarm input is triggered.
Enable Schedule
Using this parameter, you can select
on which cameras the schedule
should be activated. For example, if
you have installed the ABUS IP alarm
module, then you can use the
Secvest Key to activate guard mode
in the recorder when exiting the premises. The recording mode (duration,
motion detection, alarm) stored in the
schedule is then used. In this way,
you can activate the recorder independently from the schedule and prevent false alarms.
Ensure that the schedule is not activated initially so that it is not disarmed
during activation.
51