Download DocAve 6 Replicator User Guide

Figure 4: Example of Byte-level settings
•
With these example settings, the snapshots are kept for 365 days and the byte-level
replication is applied to any selected data whose size is larger than 200KB. In this case,
as farm TECHWRITER01 is the source, the configuration for TECHWRITER01 is used
during the replication.
•
Data size limit is intended to prevent scenarios where the act of byte-level replication
generates more system usage overhead than the transfer of the entire file itself.
2. Set up an online mapping profile. In Advanced Options, select Yes to enable Byte-level
replication.
3. Build a full online replication plan.
4. Run the replication job. If the selected content meets the trigger condition, byte-level
replication is performed.
Performing a Three-Way Replication Job
Use three-way replication in order to keep three sites in sync with one another by running two-way
replication job for each mapping. For the procedure below, let’s assume that we are setting up threeway replication for three sites: AvePoint_New York, one in AvePoint_London, and one in
AvePoint_Toyko. AvePoint_New York is the headquarters, so the other two branches must stay synced
with this site.
To set up and run a three-way replication job:
1. Within Replicator, set up a conflict profile with the settings shown below.
DocAve 6: Replicator
31