Download User's Manual - Support

Switching the Image Display Method
In the Individual results display or Position correction display, you can hide or reduce the size of images that
are displayed simultaneously with measurement information. Each press of the ↑ UP key/↓ DOWN key
switches the image display as follows:
In the Stored image display, the image display is switched between 1/4 display and full display.
OK
Individual result
353ms
Individual result
353ms
OK
Camnera 0
0.Bank00
0.Pattern Search
Camnera 0
0.Bank00
0.Pattern Search
TE
A
Judge
OK
Correlation 92
Position X 462
Position Y 352
Angle
15
Previous
No image
1/4 display
Full display
Next
OK
TE
A
Judge
OK
Correlation 92
Position X 462
Position Y 352
Angle
15
Adjust
Display sw
Previous
Individual result
353ms
Camnera 0
0.Bank00
0.Pattern Search
Judge
OK
Correlation 92
Position X 462
Position Y 352
Angle
15
Next
Adjust
Display sw
The 1/4 display is available only
for the individual results display
and position correction display.
Prev.
Next
Display sw
Adjust
The image is not displayed
while a saved image is displayed.
OK
353ms
Var.0
Var.1
Var.2
Var.3
Var.4
Var.5
Var.6
Var.7
Previous
Image display
Variables list( 0-15)
*******.***
*******.***
*******.***
*******.***
*******.***
*******.***
*******.***
*******.***
Next
FUNCTIONS USED DURING OPERATION
No image
4
In the "Variables list," "Data list" or "Judgments list" display, each press of the ↑ UP key/↓ DOWN key toggles
display/hide of the camera image.
Var.8
Var.9
Var.10
Var.11
Var.12
Var.13
Var.14
Var.15
Dsplay SW
*******.***
*******.***
*******.***
*******.***
*******.***
*******.***
*******.***
*******.***
Adjust
OK
353ms
Var.0
Var.1
Var.2
Var.3
Var.4
Var.5
Var.6
Var.7
Previous
Variables list( 0-15)
*******.***
*******.***
*******.***
*******.***
*******.***
*******.***
*******.***
*******.***
Next
Var.8 *******.***
Var.9 *******.***
Var.10 *******.***
Var.11TE*******.***
A
Var.12 *******.***
Var.13 *******.***
Var.14 *******.***
Var.15 *******.***
Dsplay SW
Adjust
Using a Saved Image to Perform Re-measurement
Re-measurement can be performed using a measurement image saved in internal memory. Images are saved
to internal memory in the RUN mode. If the ← L key/→ R key is pressed in the Individual results display or All
results/Region display, the screen switches to the saved image and re-measurement is executed.
Note
Up to 100 images can be saved. Images that were judged as NG also can be saved.
Measurement Image Save Conditions, p.147
ZFX-C User’s Manual
Checking/Adjusting the Measurement - ADJ Mode
129